notes:garmin_nuvi_660
Differences
This shows you the differences between two versions of the page.
notes:garmin_nuvi_660 [2009/01/15 17:25] – создано kibi | notes:garmin_nuvi_660 [2010/10/10 22:50] (current) – й kibi | ||
---|---|---|---|
Line 3: | Line 3: | ||
===== Как открыть корпус ===== | ===== Как открыть корпус ===== | ||
- | Flip up your antenna, at the very top you will see two screws, (These are T-5 Torx) remove them. Next be very careful when you open the top cover! The ribbon cable for the antenna comes through the bottom corner (I think it is on the right looking at the unit.) Next focus on the left bottom corner, there is a black barrel that holds the antenna to the unit and also provides the clicking steps you get when positioning the antenna. There should be a slit for a screw driver inboard about 3MM Put your screw driver there and pull to the right. Now you can lift the antenna box free. (NOT THE ENTIRE UNIT, THE RIBBON CABLE IS STILL ATTACHED.) Now at the top of the unit you will see two more T-5's under the antenna pivot area. You should be able to pry the unit open once these are removed. Still you must be careful the touch panel, speaker cable, power cable and one more cable is still attached. That one more cable you will see right away, it is red and black and you can remove it and fold the two halves over with the others still attached. After removing the final three which are all ribbon cables. Also don't forget the antenna calbe which once removed can be pulled through the half of the unit it is attached to. After seperating the halves you have the touch screen removed. You have two more phillips screws which removes the " | + | У Garmin Nuvi 660 модуль GPS находится в откидной крышке, из-за чего частая поломка связана со шлейфом, соединяющим модуль с основной платой навигатора. Так же через пару лет садится аккумулятор, а заменить его можно только полностью разобрав корпус. |
- | | + | Для того, чтобы открыть Nuvi 660 потребуется мелкая отвёрточка T5 Torx - звёздочка. Встречается редко, но бывает в наборах. Последовательность шагов следующая: |
- | * Будь очень аккуратен, | + | |
+ | * Далее очень аккуратно надо раскрыть крышку и снять её с антенны. Крышка на одном конце (со стороны гнезда для внешней антенны) снимается легко, но с противоположной имеет выступ, | ||
+ | * Вытащить подпружиненный цилиндр, который удерживает антенну в шарнире. Для этого мелкой плоской отвёрткой надо отжать его внутрь антенны и придерживая вытащить антенну из шарнира. Цилиндр подпружинен, | ||
+ | * Теперь можно снять вторую половину антенны и извлечь её. Шлейф всё ещё крепится к основной плате, и его отрывать не надо! | ||
+ | * Под снятой антенной находится ещё одна пара | ||
+ | * Теперь можно разобрать основной корпус на две половины. Открывать | ||
+ | * После разборки корпуса можно вытащить шлейфы, |
notes/garmin_nuvi_660.1232029500.txt.gz · Last modified: 2010/10/10 22:50 (external edit)